• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Search results for query: *

  1. Gregg DeGeorge

    neutral safety switch. 70 roadrunner.

    Just went through something like this on my 70:Roadrunner if you ck the starter relay wires the one on an angle think it’s yellow goes to the bulkhead plug mine pulled out a little had to jump car with screwdriver of starter relay just had to clean and push that wire in a little Good luck
  2. Gregg DeGeorge

    Wilwood disc brake conversion kit with aftermarket magnum 500 wheels

    I used dr diff kit on my 70;roadrunner think there a ford set up worked fine I run 14 inch magnum wheels haven’t updated my picture huge improvement over the drums also added power master ,my 68 was drums all around night and day
  3. Gregg DeGeorge

    1969 Roadrunner

    Thanks I’ll go back Monday
  4. Gregg DeGeorge

    1969 Roadrunner

    What’s it worth rough 1969 came up for sale 383 4spd bench seat car wrong motor needs Quaters wheel houses trunk floor has a air grabber hood but didn’t come with car I offered 3;000 he wants 5,000 car is nothing special out side for 10 years needs to be blasted ?roof surface rust vinyl top car...
  5. Gregg DeGeorge

    Kickdown linkage question

    Thanks for the info pictures helped a lot
  6. Gregg DeGeorge

    1970 Roadrunner project

    Thanks so much I did try to adjust vent window I’ll have to pull dr glass from junk dr and swap
  7. Gregg DeGeorge

    1970 Roadrunner project

    picked up new project its 1970 Roadrunner post car off this site ,Rh door was junk so found a mint 70 dr on Craigslist no rust widow rolls up and down with ease , problems when I tried to test fit door ,the vent window is hitting the trim when I close the dr ,does a hardtop car have different...
  8. Gregg DeGeorge

    Windshield Install

    Safelight put mine 1968 Roadrunner put non drying black sealer on bottom where gasket sits he worked sides up with plastic scrapper till he got top to pop in ;only problem I had was putting stainless back on aftermarket gadket to thick stainless won’t reach clips a Good luck
Back
Top