Search results for query: *

To recap,Electric fuel pumps are designed to push fuel so mount as close to tank as possible. Mount to the frame if possible and as low as possible in relation to the fuel tank. Gravity is your friend. Mount an oil pressure cut off switch to cut power to pump when oil pressure drops below 5...

Home built drive shaft ??

Type "F" from 40 years ago. Today ATF+4 . It is semi-synthetic and less foaming than type "F" and doesn't break down as quickly.

You said that you have an Accurate Exhaust system. Have you checked with them yet ?

It not only matters if you can work a wrench. but also how many times you have done that exact job. Any task done by someone who has done it many times will be many times faster than someone who hasn't done it yet. Each time you do the same task you learn from the last time you did it and you...

This mainly for vintage rims. Wheels are NOT all the same. Aftermarket wheels will have a DOT certification stamped ( or sticker) onto the backside of the rim. The early Centerline wheels were not DOT. They were changed later. Most racing wheels, tires are not DOT certified for street use. Just...

Are they the street certified wheel or the race only wheel ? The race are not designed for side loads.

Is it broken or do you just want it white again ?

From the Service Manual.

The reality is, those who lack experience in any area will likely not know much about what they are looking at. Experience is something gained through both trial and error and the time it takes to recognize both. In your position if you want to learn about the inside of an engine and what the...

Hmmm. I made the mistake of assuming. I said" if it is locked up " Not how to check it. He didn't say what he did so nobody knows if he tried to use the starter or whatever. Engine in a bottle is just snake oil. I guess a few people out of a lot more have gotten lucky I guess, and had no bearing...

If it is locked up, do the right thing and just remove it. What will you gain by possibly breaking something or causing more internal damages just to get it to possibly move. If it is locked up it needs a rebuild. No magic in a bottle is going to make it run correctly. If you insist on this ...

@ns1aar , member here. Has been doing wiper motors for 20 + years. Bruce Somer . http://www.ns1aar.com/

Cutting and replacing desiccant is the standard restoration procedure.

And don't forget the overspray that will happen in the engine bay and interior upholstery. Always does..... Get the terms of the job in writing and record the conversation on your phone.

Disassemble it yourself. That way you know where the stuff goes and it won't get "lost". Whenever someone else is working on your car just assume that things will not go well. Things promised seldom get done completely/correctly. It will always take longer than expected, they will have people...

Good for you. Just an FYI. The "authentic reproduction" hinges are from Taiwan and are not exactly the same. Replacing a door without the proper door holding fixture tool is a 2 man job. Doing it yourself is more likely to result in damage to your paint/hinge/door or hand/fingers. Follow the...

Just a note. Aftermarket wheels will seldom have the same backspacing as Factory. The factory designed rims for their specific cars, The aftermarket rims are generic and just have different sized lug holes drilled for the different brands of cars. Same wheel for all cars...

Cordoba, Magnum...same bodies.

Just surprised that the driveshaft would cause a steering wheel vibration. Interesting...