• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Search results for query: *

  1. Photon440

    The Roach

    I remember a magazine article in the late 70s (the van era) showing how to use electrical conduit to form wider wheel flares.
  2. Photon440

    The Roach

    The factory did use a plastic filler but it wasn't Bondo, it was Plastisol. The main difference was that Bondo uses a hardener to set up and harden while Plastisol used the heat from the baking oven to cure.
  3. Photon440

    70 Road Runner project

    For some reason I thought you had a Ford rear end. Chevy bolt pattern?
  4. Photon440

    318 Hemi Heads, where can I find aftermarket bolt-on kits? To run with a 6-71 underdriven low boost for street.

    Well then, rather than looking for some super rare barely produced custom heads, you'd have better luck actually getting a 1950's actual hemi engine. The smaller ones still look cool but don't cost as much. This one's sold but look for similar deals, adapters are available to use your small...
  5. Photon440

    318 Hemi Heads, where can I find aftermarket bolt-on kits? To run with a 6-71 underdriven low boost for street.

    If you're planning a supercharger, you'll have all the power you need for street cruising with wedge heads.
  6. Photon440

    LS Swapped 69 Charger

    He didn't say he was trying to sell it but if he did...a Charger shell is still worth quite a few bucks!
  7. Photon440

    Project Brown Eyed Girl.. and her 72 Satty.

    You can always make fiberglass moulds from your bumpers and blend them together, then paint the final result.
  8. Photon440

    LS Swapped 69 Charger

    Yes, I would agree that a Crown Vic has a Ford chassis. :)
  9. Photon440

    White Smoke

    I think you'll need to pull that head off to give it an inspection.
  10. Photon440

    LS Swapped 69 Charger

    Probably because it was a Dodge Charger. No other reason.
  11. Photon440

    LS Swapped 69 Charger

    I really don't think his intention was to "start a pile of crap", he did the build including turbocharging it and posted pictures. :)
  12. Photon440

    Yankee Express RestoMod Project

    I'd lean towards black bolts.
  13. Photon440

    Yankee Express RestoMod Project

    Always great to have fresh paint! It does look like pretty even coverage. Not to be critical (it could be the way the camera caught it) but some shots look like the paint has texture or orange peel. Is it actually smooth?
  14. Photon440

    I'll be the 1st to post here

    I think we'd forgotten about this thread. Thanks for the revival 69sunfireGTX. :)
  15. Photon440

    Yankee Express RestoMod Project

    One possible problem from wet floors is causing moisture in the air. It's probably okay in very dry desert air, or if you have a good flowing ventilation system blowing through your paint booth. But, ideally, just as you wouldn't paint when too hot or too cold, you should ensure proper...
  16. Photon440

    Yankee Express RestoMod Project

    This will make short work of those holes in the lens. 1803 - SMALL CLEAR PLASTEX KIT
  17. Photon440

    Yankee Express RestoMod Project

    Most emblems these days are held on with adhesives, particularly two faced tape. The pins are only there for alignment.
  18. Photon440

    Yankee Express RestoMod Project

    Day-Glo Orange. :)
  19. Photon440

    DreRacing -68 charger build (need advice)

    Quality Gear lists a 3.31 ratio. Maybe it's only for trucks? https://www.qualitygear.com/lightdutyparts/dana60.php You still have plenty of overdrive in the top couple of gears. :)
  20. Photon440

    LS Swapped 69 Charger

    Did you put the summer to use and make progress with your car?
Back
Top