Search results for query: *

I us I use some stuff from Dollar General it is called Totally Awesome I use a cheap ultra sonic cleaner off Ebay. Example of before and after. Yes in my experience the Zep products may take off the finish.

Look up the list number on the holley website will give you all the factory jetting, parts, and calibrations. I always start from the stock setup. To my knowledge every carb holley made is in their technical library.

You could try a couple things. First take the springs out under the metering rod pistons. Replace them with a stronger spring, or just stretch the spring and make it stronger, this will allow the rich step on the metering rod to come in quicker. I like to idle the engine and carefully slide...

The wire that provided voltage to the original ballast resistor should be hot key on and cranking. Safest bet would be to use that wire to trigger a relay. Use the relay to switch a wire with enough amperage to operate the pump. I thought the Holley harness had a fuel pump relay already wired...

Not sure if you want all the horsepower possible? If so a tunnel ram would do that I am sure. On the street and for the nostalgic look I would keep the cross ram. But I just like crossrams, as mentioned tuning takes a little effort but once done they idle nice and have good low-end torque.

I agree find a better mechanic. On a stock application the Carter if right, will run just as good and get better mileage than the Holley. On a race engine the Holley would run better, but you have to buy a good Holley, not a vacuum secondary cheap one. If it is backfiring out one side of the...

read this discussion Ported vs manifold vacuum for ignition advance? - Don Terrill’s Speed-Talk The short answer is it depends on your engine and combo.

I have installed both Holley and Fitech systems and used HP programmer to do swaps. From your description kind of hard to give you a cause. But The injectors are controlled by drivers basically a transistor. If the driver gets a big load on it, it will shut down. Causing a problem like you...

1969 Cuda 408 procharger, FiTech EFI frame mounted electric pump, stock tank, did use the vent line for the return no issues.