• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Search results for query: *

  1. Should be playing golf

    Car only run with key in start position .

    Ballast resistor could be Ok but the connections could be loose or corroded.
  2. Should be playing golf

    440 motor

    Definitely Permatex II and studs! No more leaky GI!:thumbsup:
  3. Should be playing golf

    Haggerty article about waning collector car values.

    Just try to get towing on a weekend going through an answering service.
  4. Should be playing golf

    Anyone have to replace a Powermaster starter?

    PS. I don't use any thermal wraps and the tech guys do not recommend a starter blanket. Must be the starter is just giving up.
  5. Should be playing golf

    Anyone have to replace a Powermaster starter?

    I have the same setup except 1-7/8" TTI's. My Powermaster starter is the #17519. A decent fit but has been working great for a few years. Call the tech guys at Powermaster, They know their stuff and will call you back. 630-957-4019
  6. Should be playing golf

    Edelbrock's real reason for leaving Cal-I-For-Ni-a

    A long time ago my father use to say it was "the land of the fruits and nuts" (even way back then).
  7. Should be playing golf

    Burnt up another starter relay

    That loose brown wire cost me a AAA flatbed ride.
  8. Should be playing golf

    Burnt up another starter relay

    There is a brown wire that runs from the ballast resistor to the center clip of the bulkhead connector that is probably loose. If that wire disconnects somehow, the car will never run. Check the connection at the ballast resistor and look to see if that brown wire (center of the three clips...
  9. Should be playing golf

    Adjustable Pinion snubbers

    Competition Engineering bars work great. Leave a little gap in them for the street and tighten them up at the strip. Leave the pinion snubber alone or just leave it at about 1" from the floor all the time. MT ET strip SS radials, adjustable drag shocks, SS springs, Dana 354, 833 tranny, 440...
  10. Should be playing golf

    Purpose of fuel tank mat

    Its for vibration and moisture control between the surfaces so the trunk floor doesn't rot out,
Back
Top