Search results for query: *

Most drill presses are variable speed If you use c-clamp vise-grips there is no control issue Cast aluminum cuts easy and slow to keep from gumming the bit, so use WD-40 Go slow

Clamp it down on a drill press and use a 3/4 end mill. Plunge it one time.

Screw heads and genders are the best comparisons I have heard yet. A new one gets created just to make it harder for it to get screwed!

I am looking for suppliers for a quality 4-Post and a 2-Post Lift and some used Pallet Racking that services Azle, Texas. I prefer a Vendor that someone has first hand experience with, multiple people would be even better. If you don't have someone to recommend, tell me about someone to stay...

I used a Dearborn space heater and propane. That kept it toasty when snow was out in Texas.

Wheelcovers are pure artwork.

Reputable and Body Shop in the same sentence? Whats next, a Dependable Painter?

A thread on dikes?

Cherry picker would work also.

I have an 8' Fiberglas sink that was used in a ceramic shop, center drain 18" deep and it can hold a rear end. Electric fuel pump and hose.

I have one of them also. We could breed them and grow some more.

I have always been somewhat poor when it comes to my tool collection. All my tools fit in a Craftsman upright toolbox. Than after watching myself pee one day I went down to Harbor Freight (which I seldom visit) and bought one of those six foot long monsters, pulled all the emblems off and call...

A good memory works also. Now where did I throw that wrench?

Ford Fucked Over Rebuild Dodge Flip Over and Read Directions Found On Road Dead

There are a lot of Mopar people that took beginner Ford classes.

Do you have a Grease GUN? An Air GUN. A mopar MAGAZINE, a Rivet GUN, a HAMMER, PRIMER, An AUTOMATIC punch?

Is it too big to store your trophy's in?

A Sign Company can print one out and put it on sheet metal for you. Pretty common today if you don't have the ability to paint.

I have seen them used in old wooden boats to set brass pins and bolts below the face surface. It was used between a hammer and the bolt.

And my Uncle Bob got these for you?