Search results for query: *

could you provide the measurements so I can build one for myself

I'd grab a lot of parts from that puppy before its crushed, all the stainless, speedo cluster, k frame if its solid

i've done it with cluster in place, if you have bucket seats take the drivers seat out whole lot easier on the body

Took the driveshaft out of my 67 Hemi automatic 8 3/4 GTX. I see the outline of 2 stripes was wondering if anyone knows what colors these would be or if there is a book that catalogs such things . I clearly see orange on the damper side of the driveshaft behind the yolk. From the dampener back...

I’ve pin pointed the 2 spots, thanks all

They must have been covered over during body , I don’t have any empty holes on top of that cowl area

On my 67 Coronet RT there are the 2 metal clamps to secure the washer hose. Could someone take a picture to show location for me. Thanks Dan

Need a little help identifying these and what’s their location Thanks Dan

.

Both of my tension rods are in the middle slot if I want to increase the lift to hold it open am I moving the rods to the slots closer to the front of car or rear of car?

Only reason I questioned that myself is the factory spacing on the other side is much wider between the screw hole and the pilot hole. On the other hand I found nothing in all my removed hardware and the mounting kit a have extra clips the same as the rest.

1967 Coronet RT, what does the clip look like that is missing from the last mounting position for the lower stainless steel moldings. Thanks

The Mopar bargain today was the red and white 68 GTX, 44k well bought, looked clean under the lights.

It only reached 105k on the block, 66 and 67 cars are hard pressed to bring big money. I’d like to have a discussion with the guy who paid 125k for an 86 Jeep Grand Wagoneer, wtf?

detroit muscle

They did the same thing on 67 coronet rt’s , if you remove the truck finish panel you will find the tape.

very nice car, congratulations. curious, I see the Ziebart tag, does this car have a bunch on holes drilled where they sprayed the protectant inside then plugged with their logo caps?

The white plastic bushings that support the shaft(high and low) that passes through the floor need to be in good shape or you lose a lot of action

X3 for booster Dewey.

http://www.evanswiring.com/default.htm