Search results for query: *

Speedo cable. Unhook it and try again Edit: accelerating at 65 oh maybe not

And leave those dumb side seals out,let the seal center itself. Fill those voids with silicone. Leaks will be gone.

Have a set of those on a 440. They work great. They all need to go to the Machine shop anyways and Marsh does a great job.

Take them off,take the reservoir cap off and keep it full,open the bleeder on one and tip it back and forth.Bubbles will come out,keep doing it till no bubbles.Tap on them too while doing it. Then install and do a normal bleed.

Yep your doing it right, that Bell is really off wow.

If it has dual valve springs I would pull the inners to break in.

How much was the bill? That will give us a good idea what's in it.Maybe

Not without modification.

I like them for retrofitting on to a stock floor shifter for full ratchet shifting. If you don't buy it I would be interested.

Rpms drop when going into gear......may need an accelerator pump

^^^^ And make sure to clean the paint out of the bellhousing hole if there is any.

Take them to a machine shop,let them take care of it for you.

Did you only press out one pin so far? Oh I see the KB236 does come with clips.That is an option.

Not sure his pistons have circlip groove's. Might be cheaper to work with a different set of used rods.

Sounds like you may not have pressed them out straight and stretched the small end.They may be shot now.

Ok, I'm pretty sure I know what could happen. If your a real dipshit you can get hurt in a bathtub full of balloons. If he is lifting straight up and the picker is able to roll back and forth and no one is pushing the car sideways it is fine.Is it the right way? Ehh, but it worked. The wheels...

Looks fine to me. As long as the cherry picker rolls easily it ain't goin nowhere. Plus it's not very far off the ground.

Cast iron is not all the same content . Some will weld up great and others like ****. Contaminants will be your worst enemy.I have used spool arc 83 successfully on these corvette manifolds. Some areas are built up an inch thick. 3 seasons on these and no cracks/leaks. These were identical...

I would give knowltons a call in East bethel MN. They have done tons of these and can set you up with everything you need.

Tractor/Truck pulling