Search results for query: *

this is what i have.

the caps on the idle mixture screws are already removed. what are the nylon bushings you mentioned?

anyone have a source for a bushing kit for the 2300 series carbs? have what i consider to be too much movement on the throttle shaft. trying to fix idle problems.

the carbs i had were pretty rough and just about anything would be an improvement. also, like i mentioned before, i did not have a good experience with the Promax replacement.

i have to ask, what small screw are you talking about? is this on the end carb or center carb base plate?

i did not. that piece is in the spare parts tote. bought 2 new base plates complete from Holley. i tried to get it squared away to enjoy the ease of adjusting rear carb. in the end, for me, it worked better to figure away to adjust a stock base plate, hence the making of the tool.

i had the Promax base plate but the machining was not accurate and had trouble getting the butterflies to completely close and one of the metering screws would not allow me to accurately adjust. as for the ooh's and aah's, i like it but i am in a mopar deficient area and they just don't get it.

tried to figure a way to be able to adjust the rear carb idle. expensive carb adjusting tools don't provide a good angle to reach screws. came up with this and worked well. purchased a spring that is used to clean commercial coffee makers and a short piece of 5/16 brake line. put a bead of...

4 and 5 go under the metering plate in the outboard carbs. i believe 5 is for 1969 style carbs and 4 is for 1970 and up.

i agree. please pm me and i will provide an address that you can send the setup to for disposal.

lewtot184 those carbs never came with check balls; toss them.. the wrong size check ball can cause the carbs to stick open at wide open throttle; i know from experience. i've experimented with check balls and my conclusions were that they were somewhere between opening too late to the kiss of...

was kind of hoping you would show what you are using for the adjustable needle valve and your source to get one.

what are you using for this adjustable needle valve for the vacuum?

is that a 500 cfm center carb?

thank you very much!!

don't have the car in front of me so I will have to ask, what is the diameter of the hole in the outboard carb where the linkage goes at the end of the throttle shaft?