Search results for query: *

Don't know how authentic these are but seems to be a start. http://www.1970gtxregistry.com/1967-71valvecoverreference/1964-71%20valve%20cover%20reference%20photos.html

Hello guys, I've managed to hook up the master kit Fast EFI I bought in june 23. I could never find a 12v constant wire to hook up the EFI. I finally just hooked fuel pump and EFI wires directly to battery. Yes it works but not with ignition switch and I'd like that. The 72 ignition system was...

Update: so, this isn't looking too bad. Since I don't have to worry about the power and ground, I am mounting the PDM over on the firewall where the resistor was. And then brought the wiring harness from the EFI to that side which is good because that's where my coil is to run the yellow wire...

Looks better than what I have now. What were you wanting for it?

Had hand surgery two weeks ago, got the stitches out yesterday. Now in an hard cast. Incisions just short of the left thumb and a small one on my lower forearm. Saw the PA. She said everything looked good although the main incision looks real angry. Pain is manageable however when the cast comes...

Performance use isn't limited to track use, but in my particular case, yes.

Toilet signs

So you're going to b tracking the car? Just curious.

Delrin and other plastics get used pretty regularly for bushings in performance handling applications. Stock bushings are very soft and allow enough movement that it's not really acceptable for a performance handling application.

I’ll buy the fronts if PB doesn’t buy them.

Welcome from Alabama, looks like you have have already found a solution for your carburetor problem.

Ok, front and rear fenderwells all prettied up... back onto the K member.

Welcome from Alabama, I have a 68 R/T 440 4-speed among others.

Nice I have Magna flow on my stroker TA 340-392

My Dad was red/green colorblind. Red=brown Green=brown Brown=gray. I understand your difficulty.

Looking for block and trans for my 70 Roadrunner Last 6 of vin 163685

Does anyone have any photos they can share of the correct style factory valve covers for a 1971 Charger RT 440? Something that shows different angles and any built-on attachments such as plug wire guides, if applicable, for the right and left side? Thank you!

Saturday is close....going to get some bananas and make me something nice for tomorrow. :p

De Havilland DH86