Search results for query: *

Off to work!

Pic

My 24 x 24 is well insulated and heated with a 220v electric with fan. One 9x7 door and a walk in door, 110 window ac for summer. I would guess aprox $40.00 per month year round. That garage panel is fed 100 amps from the house 200 service. My 30 x 50 Morton is not heated and just for...

I never heard of a brake that you can run in drive and still shifts?? I wonder if the original valve body has been replaced because that looks like it is from Joe Chrisman whose company was TranZact of indy. He has been out of business for a while. He is the only one I know that ran copper...

$35 + shipping nice piece...original paint...comes with air filter and wingnut

I will look into Carter BBD and Rock Auto. I was wondering if I needed to change out the master cylinder to a dual. The gas is very old. It's been sitting for a long time. I will need the tank to be dropped and cleaned.

Call fine lines or right stuff Any of the brake line manufacturers can set you up with most of needed parts. Get a new master on ebay for the 67 and up. Pirate jack is another source for the master cyl It's an easy upgrade

Thanks doug.. didn't think it did that much, now i know :) Place hasn't responded back bout the wrong part shipped.. probably gonna put it back together with what i have, should end up around .065 endplay which is in spec but not great, no biggy.

The rear pump feeds governor pressure. If there is no check ball driving the inner rotor the trans will not shift out of 1st gear. If I remember correctly with a stock valve body the front pump pressure is bypassed and the rear pump supplies fluid pressure for clutches and bands when the vehicle...

I tried again, but still says your inbox is full. You may need to refresh your browser, empty your cache or something like that. When you get a chance.

I’ll take them. PM sent.

Sweet I love the back of the 62 savoy.

Good stuff! #4 Actually, for that distributor you needed to have the ballast resistor. So, you were good there. Do you have a test light and some form of volt/ammeter? Basically, check one of those wires at the resistor for power when the key is ON. Then, turn the key to START to see if it...

Here are the tops

Delrin is pretty unforgiving, requiring precise alignment. Not many street applications will see this benifit unless certain machining steps are taken to ensure no binding occurs. I've seen delrin bushings broken in two. I doubt your're going to see this type of alignment in any B-body...

Bump. A couple more pics, I know how everybody likes pics...hahahaha

Looking for a nice set. EK2 is a bonus. Shoot me a message, Thanks!