Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Many overlook the benefits
of a custom set of headers.
They are comparably priced
and if you find a good
builder, he can overcome
many of the problems
associated with vehicle
serviceability.
I had a set custom built and
had to pull the Turbo 400
out from under the tight
confines of a Jeep CJ7...
Ok, I very carefully installed my wire set-up on my 727, making sure the hole on the carb lever was exactly where it should be (I took the special mopar bouchillion throttle plate to double check with.)
I tested several arms (Different lengths) down on the throttle lever on the 727.
I got a...
There we go. I wonder if the factory parking brake cables will reach? That's be fantastic.
Anyone know a source for the axle flange studs? I've got a couple I'd like to replace. Instructions for how to do it would be good too.
Nope... and I believe newer style power valves have blow back protective feature - but I may be getting confused with the accelerator pump!?!?...Anyways, I replaced the Power Valve earlier today and drover it around etc, been parked up for 4 hrs now, and the level is staying constant in the bowl...
Likely brazed? Any good repair is going to require taking it apart, and cleaning it up really well before putting flux on it, re-assemble and braze or solder.
If you only need a temp fix, maybe clean it up and JB weld it.
Older style green bearings that don't allow for flexing like the newer versions with the snap ring.
Biggest install problem I have seen is when the diff pin is retained, the axles will be just slightly too long.
You can tighten the bearings down, but the rollers will be loaded towards the...
I did the green bearings when I did the rear disc setup, and found the only reason to use the green bearings is so the axle stick out is consistent on each side.
The factory taper bearings could be used. Just have to set the end play, and then shim the caliper brackets correctly for the amount...
Yes, a 1973. No louvers in the hood. The white car attached.
I usually see the louvered hoods on 1974+
A few months ago, I was moving the Jensen out of the garage, and the left side front brake hose blew out, so even more leaks and things to fix on the car.
I don't know a ton about the Jensen...