Search results for query: *

74 Charger 8.25

Someone on ebay has a front sway bar for a 73-74 B-body, part #3722411. Looking in my parts book it fits a big block car. Does anyone know what the diameter would be? Can't get hold of the ebay seller. Thanks

74 Charger Midland Ross. Took it apart and when the spring sprung parts went flying. Does anyone know where those three little rubber pieces go? There could be four not sure.

Came out of the fuel tank on the 74 Charger

Is the gap correct on this cross member? Its on a 74 Charger, small block automatic. Thx

of the rear sway bar to the frame? This is on a 74 Charger. Are they self tapping? There are no holes there now because I am adding the rear sway bar to the car. What dia., length and would they be a grade 5 or greater? Thanks

I record Graveyard cars. Last night I watched the one that Tony of Tony's Parts and Mark were looking at a 71 RR. Tony said that the windshield of the 71 RR was the same on all B-bodys from 71-76. That would include 75-76 Dobas, RR and Chargers. Is this correct?

Mine are off the car (74 Charger 318 car) and they both have a slight bow. I roll them around on the shop floor. One side touches the floor, 180 around 3/8" off floor. Is this good or bad? I guess I should add torsion bars.

From a 74 Charger 318 car. Just pulled K member and found this. Looks like someone put a tow chain on here. The one weld is busted as you can see. But the up and down support is intact. Can I heat this up, hammer it back in place, and weld it up? this is on the left (drivers) side.

I am in need of a rocker panel on the right (passenger) side for my 74. The one on the car now is shot.

How hard is it to replace a rocker panel on a 74 Charger. Talked to a guy with a 71 Satty that said he would cut out what I needed. Looks like a lot of work to replace. But I don't know what else to do.

I am adding a center console to my 74 Charger. I bought the console from one person and the three brackets from another. I need to know what fasteners hold the console to the brackets and what fasteners hold the trim ring and boot to the floor. The shop manual and parts catalog doesn't give me...

I have a question on a E-body. I bought a rear floor pan for my 74 Charger about three years ago. I went to install it and it did not fit. After some research I think it's for a 70 E-body. It is a rear drivers side foot well. Is there someone that can confirm this? Maybe someone is on FEBO. It...

I found a Rallye gauge cluster in a junk yard for my 74. It has NOT been cut for aftermarket radio. But it is cracked all the way through below the radio opening. Can this be fixed? We have not talked price so I can use the crack to my favor.

Does anyone have a pic of a speed control lost motion bracket for a 74 Charger? The parts book pic is not very clear and I need to buy one. Thanks

Is there a repair for the plastic covering around the braided part of throttle cable? Thanks

Found this brake/stoplight switch for cruise control, part # 2947798 for sale. Need to make sure it will fit my 74 charger. Thanks

I took my rusted trunk floor out in pieces on my 74 Charger. I tried to put the new one in for a test fit and it would not fit. The forward end would go around the wheel wells but the aft end would not go through the trunk opening. Anyone ever have this problem or know how to fit it in?

On my 74 Charger should I rebuild the door hinges or buy new ones made by AMD which are made in china. The old hinges are not that bad. Has anyone rebuilt theirs?

I have a 74 Charger. The door jam sticker says tire size was f78-14. I want to put Magnum 500's 14 inch wheels on the car. why not?