Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I don't know which is more disturbing.
The modifications or the fire.
I think it had a run in with Christine.
Or the Bat Mobile.
At least it would be stable sideways on NASCAR.
Still needs the trunk spoiler though...
I'm not aware that anyone is reproducing the correct threaded trunk lock cylinder let alone the bezel.
And even if they were the cylinder mechanism is still out in "the elements".
This is a new trunk lock with the clip like all the other locks use.
Typical B body.
Pardon the dust.
Under...
https://www.ebay.com/itm/1966-1967-DODGE-CHARGER-CORONET-RADIO-DELETE-PLATE/372523141383?ssPageName=STRK:MEBIDX:IT&_trksid=p2057872.m2749.l2649
I went with this and was amazed at the quality.
I couldn't find anything "wrong" with it.
I think he makes them, so contact him for one if there are...
I only see two types of vintage cars on the web and both are Chargers.
Way to cool not to have at least one?
My 1/2 drive impact wrench is 38 years old.
It is a Chicago Pneumatic that was made in England.
(True)
Bought it at an auto parts store on Main Street in East Point GA that was "Direct...
https://news.classicindustries.com/1966-dodge-charger-the-start-of-a-legend
My daily is a fold down rear "Duster".:)
Unfortunately , I don't own a surf board.
But I can get most anything else in there.
And I have.
Have I got it wrong?
Does the A pillar go under or over the side piece?
Checked before installing and it looked like the A trim goes underneath the side trim.
Everything fits but here.
Are they supposed to butt or overlap like I thought?
I had to pull the new tank and lines from the 67 Charger to access the new fuel sender for calibration.
We replaced the tank, lines and sender before starting on the car a little over 4 years ago.
The problem is that the "new" rubber hoses are 4 years old and all three elbow pieces have severe...
Just curious.
I'm doing a major re-wire.
I've found several errors in the factory prints from the 67 manual.
(Now I'm installing a custom fabricated fuse block)
I see no provision for lighting on a column mounted gear selector in the prints.
I feel sure if it does light up it will be from the...
There are a few differences in these cars.
I don't think there is any guidance on the internet about some of the peculiar things about 66-67 Charger interior.
I just finished and would like to ask if:
Is there enough interest in sharing what I learned?
I did somethings better than factory.
I...
I'm familiar with the later threaded stainless whip antennas that you can screw out of the base.
But this whole is not threaded that I can see, so I'm assuming it was a press fit perhaps?
From looking on the internet it seems the car had a segmented antenna.
And the whole thing is being...
I'm doing an extensive rewire on a 67 Charger.
http://www.forbbodiesonly.com/moparforum/threads/rotating-headlight-relay-modification.135356/
The undisturbed factory wiring harness had fuse in the "power" wire to the emergency hazzard flasher It also did not go to the place it indicated on the...
I have not installed this yet.
Let me know if I have any of the contacts wrong or other feedback.
I'll go ahead and post it because I see some people are asking about relays.
(Don't exist apparently)
It uses the same Bosch relays that "we" use for the headlight power supply mod to eliminate the...
I have starting to put the dash in the car.
I have no memory of removing a heater shut off valve or a control cable from the controls to the engine area.
I have been through the parts manual and service manual and I don't see a heater valve under the hood.
Am I correct in thinking that the car...
I thought that cleaning up and pulling the headlight wiring out of the factory prints would be helpful. Rotating headlights and dual lamps.
I could use a fresh set of eyes.
Maybe print them out and compare them to the originals.......and if I've made any errors point them out. I'm using 67...