Search results for query: *

Chrysler 440 source added a few new pages....great pictures

Did a mock up using Mopar cast valve covers and Felpro gaskets MS 90425. I cant remove the passenger valve cover unless I loosen the manifold. The extended gasket makes it too close to the valve cover. Any ideas?

Top bolt is a BB crank to flex bolt. second row crank and/or flex bolts, third row??

Found this in a pile of brackets in the garage. Not sure what it is, any idea??

Replaced gas tank and sender and now the gauge reads zero. I ran an extra ground wire from the sending unit to ground, but still nothing. The only thing I altered is that I put a thin rubber strip on the straps for noise purposes. Could this be the reason?

Just tried to go on it . Hundreds of posts in Chinese or Korean......... what a mess!!!

1972 Charger changing over from column shift to floor shift. When I went to drill out the floor I found two small holes. One plugged and one open. Are these factory holes? Take a look.

Got a call from a friend. His neighbor is selling a 69 Charger R/T J code car rolling shell. He says the car is in nice shape. No rust original panels. Needs motor and tranny. I dont have any pictures at this point. Whats a good price for a rolling shell in nice shape? Thanks

Im removing the centerline wheels from my car and going to Magnum 500s. Rear end has three inch studs. Should I remove the axles or just cut the studs or just leave the studs with the magnum 500s? What do you guys think. Dana 60

Im looking at a set of mechanical carbs. It looks like the float adjusting nuts are offset on the mechanical carbs and will hit the stock air cleaner. Anyone have experience with them?