• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Search results for query: *

  1. Moparmatt72

    Trick flow

    I know alot of you have heard of theit new heads for the 440's, but I wrote them and they said they have been getting alot of requests for them to make small block mopar heads and they said they will seriously be looking into it so hopefully they do come out with something and add more options...
  2. Moparmatt72

    Oil flow confusion

    Okay myself and my dad are confused. I get oil when manually primping the system to the left bank but nothing to the right, ran a wire down the oil feed goes to cam, oil gauge reads 80 psi with the drill going. Any ideas?? Engine is a 440 with stealth heads. The rockers on the right side aren't...
  3. Moparmatt72

    Freeze plugs

    Does anyone else have issues with these? The motor has been built for a little while, just got everything ready to finally start it and when I was filling the coolant system the back two freeze plugs both banks started to seep. Banged them out, installed new thicker ones and it's still seeps...
  4. Moparmatt72

    346 cast number heads

    Just wondering if any of you have info on these good or bad ?
  5. Moparmatt72

    My Dana 60

    I pulled this out of a GMC truck, ill be putting new tubes on for my 72 B body, my question is I wrote strange and they told me that for a bbody that housing end to end measures 57 3/4inches. I bought some 15x10 with a 5.5 backspace, but I also have some offset shackles. To get the max amount of...
  6. Moparmatt72

    Mopar race intake

    I gonna be building a twin turbo set up in a while, I came across the mopar race intake, looks like it has bigger runners then the M1. My question is has anyone ran this intake on any set up or had it and switched to a eddy manifold? Did you notice any difference?
  7. Moparmatt72

    cam degreeing

    Okay so I know you go 0.050 on both sides of the lobe then you add the two numbers and divide by 2, what do I do with that number afterward? Sry its my first time to degree a cam. My cam card says my degree is 108 but will still degree to double check. Thanks
Back
Top