SOLD 1963 Plymouth Belvedere project for sale

Not open for further replies.


Feedback: 2 / 0 / 0
Local time
11:18 AM
Nov 20, 2020
Reaction score
New jersey
I purchased car around 2 years ago, I have too many irons in the fire and will never get to this vehicle... so it is time to sell it. Car came from out west, first pics of The car being unloaded from the trailer are from when the car was first delivered to me. Car has been kept in my warehouse since I bought it, only thing I did in the past 2 years is basically unload all the parts and pack them away. Title is from Arizona and is signed and notarized by the last owner, I never titled it in my name.

Body : Rear Window lower channel needs some patch work (pictured) along with the driver side rear window corner (pictured). Passenger side rear quarter lip and lower quarter have some rust issues (pictured) and would need to be addressed. Trunk pan center has a few rust holes and will need to be patched. Rest of car is solid...fenders doors, floor, driver side cowl, etc.. Car comes with new sheet metal I purchased from Kramer automotive which includes passenger side quarter panel patch, lower quarter patch, and lower trunk drop off for the same side... also have a lower quarter panel patch for the driver side if needed.

Interior : Front and back bench seats will need to be recovered, door panels are shot but they still have the metal uppers on them which is a good thing. Headliner is shot, headliner is rolled up along with the headliner bows. Dash is in pieces but seems to all be there. I could not find the WIREHARNESS for the car.

Engine / Trans : I have a 1963 413 wedge motor that will go along with the car, block acting number # 22056974 date 8-17-62. Motor is disassembled and packed in a crate, motor will need to be rebuilt. I had a shop by me check the block for cracks, they said it was all ok and still at standard bore... if I can find the paperwork I will include it. Car has no transmission.

Glass / Trim : All side glass in in good condition, passenger quarter glass is not installed but in good condition. Windshield and rear window I do not believe are for this car, the seem like they are to small. Trim... I would say that 98% of the trim is there including the hard to find square trim that goes around the rear license plate... I do know that one of the front fender molding spears was not found when I looked through the parts.

Parts : here is a list of what is included with the sale of the car, I collected some parts and they are all included.
413 engine that needs to be rebuilt
426 re issue cross ram exhaust manifolds
4 speed pedal setup and crossmember
3.23 8 3/4 742 center section.
Front and rear lights
Repair body panels

I believe that’s all the info but if anyone needs more information or pictures please let me know.... site is saying that I can only load 10 photos. Car is located in Roselle New Jersey, which is 1 hour from my house ... so i need An ample notice if anyone would like to look at it. Asking $8000 or best reasonable offer.










Not open for further replies.