https://tucson.craigslist.org/cto/d/tucson-1965-dodge-dart-170-wagon/6865713283.html Up for sale is my '65 Dodge Dart 170 wagon. It is complete, but does not run. I bought it as a non-op project, and I never got to it. It has the original numbers-matching 225 that turns over, the original A903 trans, and the original 7-1/4 rear differential with 3.23:1 gearing. This is a low-optioned, base-model car. The only options this car have are the bigger Slant-6 engine, and an AM radio. It was manufactured in Los Angeles, sold out of a dealership in Sierra Vista, AZ and has been in the desert its whole life. The only rust on the car is the rear floorboards where the car sat outside for years with leaky window seals. There are many spare parts that come with this car that I have collected, including a complete 225 engine that turns over out of a '68 Dart, an A903 transmission out of a low-mileage '70 Duster, a U-joint drive shaft, 15" wheels from Wheel Vintiques with new tires, very nice dog-dish hubcaps, trim parts, a nicer rear bumper, new reproduction floorboards, a reproduction billet aluminum gas cap, a super-six set-up (2 bbl carb, both an aluminum and cast iron intake, distributor), factory jack, 14" spare rim from a '72 Scamp (15" won't fit in the space), aftermarket performance aluminum radiator, many interior parts, service and owner's manuals, specific vehicle information from the factory, and other extras. I also have other parts for sale that I bought for this car, including A833 4-speed transmission w/ V8 bell housing and 8-3/4 Sure-Grip rear differential (3.23:1), torsion bars, and the center link from a '66 V8 Dart GT (small bolt pattern), an A833OD 3-speed overdrive transmission w/ slant bell housing out of a Dodge Aspen (direct bolt-on), rebuilt Hurst floor shifter and new linkage, Kelsey-Hayes front disk brakes from a '72 Scamp (small bolt pattern), Bigger drum brakes out of a B-body, the tunnel floor section for a 4-speed from a '66 Barracuda, and a steering column with no shift collar from a '64 Valiant, and a new, reproduction 2-volume 1965 Chrysler parts catalog set. NOTE: These parts will not be sold until the car is sold, so please don't contact me asking for any of these parts unless you intend on purchasing the car. Once the car is sold, I will list the parts for sale here. $2000 firm. Will do Paypal for a forum user (buyer pays fee) and work with a shipper on a non-local sale. Thank you.