- Local time
- 8:32 PM
- Joined
- Sep 6, 2009
- Messages
- 1,332
- Reaction score
- 1,067
- Location
- Boulder City, NV.
I have a fully show polished Tunnel Ram for 440 with std. Height
(Non Max. Wedge) Cylinder Heads
The 4224 660 Center squirter were new bought new and sent to
Walter Ritchey @ Silver State Race Cars to be prepared and flowed
These carbs require extensive work to run cleanly with good response
($1,650 including flow Bench)
The linkage is Custom Enderle Ball Bearing fabricated for side Mounted
Carbs.
This set up ran 9.70 @ 131 at 2500 ft elevation in my 70 Duster at 3400 Lbs
with Edelbrock Heads and 4.56 Gears. the engine was a basic 11.5 to 1 440
(Not a stroker)
I have over $3,200 invested in the set up but I am in my 70's and not licensed
to run that fast anymore and will not be = so I went back to a small 4150.
$1,450.00 Plus the ride
Can Deliver in So Cal/So Nevada
(Non Max. Wedge) Cylinder Heads
The 4224 660 Center squirter were new bought new and sent to
Walter Ritchey @ Silver State Race Cars to be prepared and flowed
These carbs require extensive work to run cleanly with good response
($1,650 including flow Bench)
The linkage is Custom Enderle Ball Bearing fabricated for side Mounted
Carbs.
This set up ran 9.70 @ 131 at 2500 ft elevation in my 70 Duster at 3400 Lbs
with Edelbrock Heads and 4.56 Gears. the engine was a basic 11.5 to 1 440
(Not a stroker)
I have over $3,200 invested in the set up but I am in my 70's and not licensed
to run that fast anymore and will not be = so I went back to a small 4150.
$1,450.00 Plus the ride
Can Deliver in So Cal/So Nevada
Last edited:
