FOUND 49.27" Driveshaft (2 3/4 diameter)

[Machmeter1]

I know its the wrong forum, but maybe somebody has a drive shaft for my 69 Barracuda. According to the service manual, a 904 and 8 3/4 combination came with a 49.27" driveshaft.

Thanks and stay safe,
Wolfgang

 

[oldkimmer]

Is that ctc of the u joints? Kim

 

[Machmeter1]

Yes Sir, should be center to center.

 

[oldkimmer]

I’ll check mine next week. Do u need the yoke? If so 904 or 727 size? Kim

 

[Machmeter1]

Hi Kim, I have the yoke, but may take it too. Thanks, Wolfgang

 

[Mopar John]

I still have my 49 3/8" or 49.375" 904 shaft?

 

[oldkimmer]

That’s pretty close and should work and a lot closer. Kim

 

[Machmeter1]

I still have my 49 3/8" or 49.375" 904 shaft?

you have PM

 

[Machmeter1]

Still on the search...

 

[HEMI-ITIS]

Have you priced one from the local drive shaft shop??Would be a good time to go to the larger joints. I like larger joints......LOL

 

[Machmeter1]

I would like to have an original one, but already play with the idea to get one custom made. I do need a large u-joint for the 8 3/4 but a small for the slip yoke to the 904 trans.
Thanks Wolfgang

 

[hunt2elk]

I have one that came out of my 70 Duster. Was a New Mexico car, so it is in nice condition. This one measures 49 1/6" c to c though.

 

[Machmeter1]

Well, 70 Duster has same wheelbase as my 69 Barracuda (108"). So if your Duster had a 904 and a 8 3/4 rear, or a manual transmission in, it should be the right part.
Gonna shoot you a PM,
Thanks Wolfgang

 

[hunt2elk]

318, 3-speed manual, 26 spline, 8 3/4 rear.