• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

WTB 64 Polara parts and info

mccoymail

Well-Known Member
Local time
9:26 AM
Joined
Nov 30, 2010
Messages
446
Reaction score
308
Location
Johnstown, Ohio
Feedback: +0 / =0 / -0
Folks -
I have recently acquired a 1964 Polara that is the typical unfinished project that was forgotten. To clarify what I have versus what I need, I have realized that I know very little about part interchangeability on pre-1968 Mopars. I would appreciate any insights here on that issue.
What I know I need soon are deck lid torsion bars and headliner bows.
Appreciate you guys and the help over the years -
Thanks
 
Decklid Torsion bars are the same 2 and 4dr while convertibles I believe are different. Headliner bows are Hardtop and Sedan so depends on your roof. Lots of the 63-5 parts like that will interchange.
 
current state as purchased

1.jpg
 
Nice looks like you picked it up at the Mopar Nats as I recognize the place from a few days ago. Trim holes looks like a 440 model not a "Polara".
 
Nice looks like you picked it up at the Mopar Nats as I recognize the place from a few days ago. Trim holes looks like a 440 model not a "Polara".
Again - not really familiar with these so I value your knowledge. Titled as a Polara but that doesn't mean much in todays world!!
 
I have the trunk lid torsion bars from my 65 Belvedere. I will give them to you, you cover postage from 49349, midMichigan.
Mike








I
 
I just sold a complete front bumper with them on it... I might have the rear ones on a bumper. Can check during the week.
 
Back
Top