Ball joint boot source?

[Red_Rocket_1965]

Anyone have a good source for exact replacement dust boots for ball joints? These are for the tie rod and idler arm joints in a 1965 Coronet…switching to the drop center link because of oil pan contact and ripped the old boots with the pickle fork.

I ordered some from energy suspension and the inner hole is too large and overall way bigger than the old one…not sure that is a huge issue once it is compressed but doesn’t like the best seal that way. Just a ton of options out there and want to narrow it down…hopefully find the exact same ones.

Thx!

 

[DeltaV]

Craig @mobileparts may have them, or know where to get them if they are still available.

 

[Charlie Brown]

Try this - https://www.chryslerclub.org/PDF files/GOERS.pdf
pg 47 / 48, items 419, 283, 286
Some of the stuff he has fit B bodies. Gary Goers no longer runs this company and is now owned by Quiery Design.

 

[YY1]

The issue I had with energy suspension tie rod boots is they have no bottoms that snap into the boot, like OEM and grease just pours out of the gaps.

 

[1STMP]

"Rubber The Right Way"
"Metro Moulded Parts"
"Vintage Part Source"
Are three sources I've used.

 

[Red_Rocket_1965]

I was able to find pretty good sized replacements at suspension.com - you can spec them based on height, width and hole size. https://www.suspension.com/universal-dust-boots.asp

Part #19-1725 is closest for me https://www.suspension.com/191725