• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

WTB Drive shaft

Status
Not open for further replies.

Joe Jacalone

FBBO Gold Member
FBBO Gold Member
Local time
7:50 AM
Joined
Sep 7, 2021
Messages
120
Reaction score
84
Location
St. Augustine, Florida
Feedback: 0 / 0 / 0
I need a drive shaft for my 1966 Belvedere II. I am installing a 440 with a 727, and it has an 8 3/4 rear.
 
I think i have the driveshaft you need, out of ‘67 satellite. with a 360/727, 8-3/4” rear. I’m think trans should be mounted same location regardless of big block or small block. Have you measured yet?
 
I have not measured because I don't have the engine and trans in yet. If you will hold it for a few days, I will get back to you.
 
Status
Not open for further replies.
Auto Transport Service
Back
Top