David Stillie
Well-Known Member
I recently got my Charger out of the body shop and it looks fantastic!
The body-man adjusted all the panels perfectly. The engine is ready to go in.
I always thought that installing the engine from the bottom was overkill, but now I think I'll give it a try. The thought of a scratch is just too much.
Anyway, I figured I would built a K-frame support that I can also use to break-in the engine. I used some scrap lumber and some car roller skates. I will built a support for the rad and electrics as well. I'm sure I am not the first person to think of this. Looking forward to hearing this engine run!
The body-man adjusted all the panels perfectly. The engine is ready to go in.
I always thought that installing the engine from the bottom was overkill, but now I think I'll give it a try. The thought of a scratch is just too much.
Anyway, I figured I would built a K-frame support that I can also use to break-in the engine. I used some scrap lumber and some car roller skates. I will built a support for the rad and electrics as well. I'm sure I am not the first person to think of this. Looking forward to hearing this engine run!