• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

SOLD MAX WEDGE HEADS, INTAKE, ETC. READY TO RUN...

Status
Not open for further replies.

coloradodave

FBBO Gold Member
FBBO Gold Member
Local time
12:10 PM
Joined
Jun 1, 2011
Messages
3,736
Reaction score
3,113
Location
Lincoln, CA
Feedback: 17 / 0 / 0
Contact seller
Time for a change. Basically selling my factory max wedge heads, crossram and associated parts to turn your plain Jane 413, 426 or 440 into a Super Stock clone. The lot price includes the following, ready to run:
1) #2402286 Max Wedge ported heads. Fresh valve job and Viton seals.
2) Used set of ARP head bolts and washers.
3) 4 bolt valve covers with breather and PCV set-up.
4) Complete set of Comp Cams Magnum 1.5 roller rocker arms with hold-downs.
5) 2 Sets Trick Flow pushrods for hydraulic lifters - oiling and non oiling.
6) Factory crossram intake manifold, #2402726-1 Dated: 12-17-62. Ported to match heads.
Includes hold-down bolts, bellcrank and linkage arms.
7) 2- #1404 Edelbrock 500 CFM carburetors - manual chokes - less than 2,000 miles, disassembled, cleaned and stored inside. Stock jets and metering rods.
8) 2 #1486 Edelbrock calibration kits with extra jets/rods.
9) Custom Unisyn carburetor synchronizer.
10) 7 extra sets of Fel-Pro valve cover gaskets and 4 extra Wix air filters.
11) 2 reproduction air cleaners.
All parts are in very good condition and can be bolted on and run.
Would like to sell as a package for $6165.00 plus shipping from 95648.
Please PM for more pictures or with questions.

DSCN0049.JPG DSCN0050.JPG DSCN0055.JPG DSCN0057.JPG DSCN0061.JPG DSCN0067.JPG DSCN0069.JPG DSCN0081.JPG DSCN0084.JPG DSCN0085.JPG
 
Last edited:
For those that have asked, more photos: Lot of all parts shown in Posts #1, 2 &3: $5,500. plus shipping
DSCN0116.JPG
DSCN0117.JPG
DSCN0118.JPG
DSCN0122.JPG
DSCN0123.JPG
DSCN0124.JPG DSCN0125.JPG DSCN0126.JPG DSCN0134.JPG DSCN0136.JPG
 
New Year! New Price! $5,200. plus shipping. I know it's a lot of money, but if you want the original max wedge heads, crossram, linkage, etc, and all the parts ( minus distributor) to outfit your shortblock and get it running, this is probably the quickest and cheapest way to do it. Please note: The heads & crossram are ported and port matched; the carburetors are almost new Edelbrocks (not old, originals); the rocker arms are aftermarket Comp Cams rollers, so I am not appealing to the "must be factory, untouched" crowd. On the other hand, this set-up on a 10:1 compression ratio 440 will pin you to the seat...
 
Status
Not open for further replies.
Auto Transport Service
Back
Top