Hi fellas,
Just finished fabrication and welding of my bolt-in driveshaft loop today. As can be seen, I already replaced the tunnel but wanted/needed a safety loop. I used 3' angle iron for the main supports, 16 gauge to reinforce the tunnel, and sections of 2" square tube for fastening the loop to. I made it adjustable as I have no shaft yet. Lots of work but, it's rock solid.
Mike
Just finished fabrication and welding of my bolt-in driveshaft loop today. As can be seen, I already replaced the tunnel but wanted/needed a safety loop. I used 3' angle iron for the main supports, 16 gauge to reinforce the tunnel, and sections of 2" square tube for fastening the loop to. I made it adjustable as I have no shaft yet. Lots of work but, it's rock solid.
Mike
nice job.
