After rebuild can't get the drain plugs sealed.
They have copper O rings.
No new ones were in the kit.
Picture is of an old carb to show location and one of the plugs. And the rebuilt one on the engine.
In and out several times now.
Tried sewing thread and thread cleaner and tightened them as tight as they would go.
These are directly below the float bowl so it empties the bowl over nite, so it will not start without priming.
Any suggestions?
It's on my 65 Coronet, 273 V8.
They have copper O rings.
No new ones were in the kit.
Picture is of an old carb to show location and one of the plugs. And the rebuilt one on the engine.
In and out several times now.
Tried sewing thread and thread cleaner and tightened them as tight as they would go.
These are directly below the float bowl so it empties the bowl over nite, so it will not start without priming.
Any suggestions?
It's on my 65 Coronet, 273 V8.