Search results for query: *

Do a resistance test on the switch using the ohm function on your multimeter you should have 0.0 ohms when in the on position and OL when in off position, if you have OL in both positions bad switch

Nice 69 Charger welcome to FBBO from NorCal Sierras

Well I put a few posts up asking about a place called Masta Performance and got zero replies, But they claim to be able to duplicate my original tube for about 50 bucks. I’m going to roll the dice and see how it turns out. I’ll let y’all know.

yes, 64 Dodge Polara

$2500. :screwy:

I believe high connection is the condenser.

Hi everyone, thank you for the add. I am currently restoring a 69 dodge charger. Located near Ottawa Ontario Canada. I know I will need a lot of help as I go. I’ve gotten some help looking through the forum here before but now I have joined so I can participate too. Here is the current state of...

To be perfectly honest, I just run Standard Ignition wires. I'll probably get crushed for this but unless you're having misfire problems, high performance wires and coils DO NOT add power. You cannot make more power by super igniting the mixture, it either ignites, or you have misfires. This...

Thanks for that I was wondering where the new connectors as I am confused where the low side and high side goes

Where are you finding these in 2024? I have been adjusting the repop tubes and they work just fine.

I found Megaparts is selling repops on E-bay now but since you went to the trouble to look into it how much would you want with shipping to 85308

Before you do any vacuum or charging, change our the condenser for a parallel flow one designed for 134. Will make a difference.

The problem you're having is due to the motor mount change in 73, all the repo dip sticks are for 72 down. The spool mounts need some different bends in order to fit right, and to my knowledge nobody is reproducing them. The only solution I could find was to get a stick and tube for a big block...

Bob I'm sending a PM

sexist, racist, homophobe, the list is long :rolleyes: I'm just an average white guy :elmer:

Sent info to you

My street Challeger runs a 360. It has a Crane 669621 hyd roller (222/[email protected]"). Crane 1.6 rockers. What ever length pushrod it took to get the adjuster in the correct location. I wasn't thrilled with the length of the Crane rocker. So lash caps were used as an extra measure for more tip...

Put charger on lawn mower. WHOOP!

not much there …