dart14
Member
what is the correct installation depth of the rear bearing on a roundback alternator ? Should it sit flush to the rear case ?
Pic 1 is current alternator where bearing sticks out about 3/32 from rear case
Pic 2 shows inside of rear case where bearing is flush to inner case
Pic 3 is previous alternator where bearing is flush to rear of case
I dont want to hammer the bearing in any unless necessary. The unit spins freely and the bearings seem tight
Pic 1 is current alternator where bearing sticks out about 3/32 from rear case
Pic 2 shows inside of rear case where bearing is flush to inner case
Pic 3 is previous alternator where bearing is flush to rear of case
I dont want to hammer the bearing in any unless necessary. The unit spins freely and the bearings seem tight