65 coronet,440 engine. have two bells ,one 10.5 one 11. two flywheels one for 10.5 one for 11. have a new clutch/plate for the 10.5. Am leaning toward the 10.5 set up but only want to do this once.street driven only.Any suggestions welcome,thanks.
bell housing
- Thread starter ukieone
- Start date
Sounds like you have a complete 10.5 setup so I would use that. Verify the bellhousing matches your transmission bearing retainer first though.
the whole setup is from a 66 sport sat. incl. the trans.
Wmcmackin
Active Member
Im running a 10.5 bellhousing and clutch setup in my 65 Plymouth I was told they fit in the tunnel a lot nicer than the 11 inch setup
Similar threads
