I forgot PST had a separate sponsor's forum here and my post up in the Suspension & Chassis section wasn't getting much response. My 66 was sitting very uneven in the front and I ran out of adjustment on one side before I could get it up high enough. Crossmember and sockets are all like-new condition. After pulling the torsion bars I found the one marked "L" was on the right side and vice-a-versa so I'm assuming the reversal has damaged the one bar. I believe the bars are the .92" ones and I would like to install .96" ones for just a bit more stiffness. The only ones that come up for my car on PSTs website for my car are 1.03" which I fear will be just a bit too stiff in combination with the 1.25" sway bar. Does PST not carry a B-body torsion bar somewhere in between .92 and 1.03"?