Recent content by 2blader

Nvrmind I got it. Sometimes I am an idiot.

So I have a few leaks which have plagued this car since I bought it. The outlet has a compression fitting added to the end to change it to AN fittings. I replaced the sending unit seal a ways back but just got around to being able to drive it. Yup filled it up and noticed it again after I...

Yea it have been a long expensive road…BUT the car was too nice to leave sit there and rot.

The cam that was .283 @ .050 idled at 1300-1400 rpm. When I called Bullet, the cam manufacturer they laughed when I told them it was in a street car. IF I had a 572 CID Hemi I may not have had to do it. 472’s are kinda small by todays stroke standards. This cam made almost 740 hp at 7000 out...

Whelp, been a long time since I visited with you guys. IT has been a LONG friggin haul with this car. Had tons of issues and finally back where I can drive it when the rain stops. Just a quick look back. I installed two O2 sensors on my 472 Crossram Hemi hoping to get it to behave. I also...

TY but why not a Grant wheel? and who else makes them? TY Scott

First do not have an OEM wheel. Second, do not want to buy somebodies junk. Third, nothing on the car is stock so a mint OEM wheel would be a waste on my car.

Looking for any ideas on a OEM type reproduction wheel for a 69 Super Bee. Looking for insight from those that actually bought and used an after market wheel. Thanks, Scott

Thanks Bob.

Was thinking along the lines of this. This way all my mounts still work. Proform Parts 440-473 Proform Alternators | Summit Racing

So I have dual electric fans on my car and when they kick in it kills the idle on the engine. 472 Crossram Hemi. I have some polished alternator on the car now and hate the look anyways. It looks to be a square back and has a small regulator like attachment wired to the rear of it. Is that a...

Not to sound dumb but is there room for the master cylinder for the clutch pedal etc. with a Hemi in there? I am coming over from BBC Chevelles so these Mopars are alien beings.

Whelp, Hemi is out for a cam change. Trans will be gone through cuz it is already out. Might as well do the hydraulic throwout bearing too. Need a few opinions on what kit to use. Maybe the kit from Brewer’s? Thanks in advance. Scott

Got it taken care off

Yup this change helps alot and made a few of these for a few friends with non Hemi engines. I will be back to the O2 stuff after I replace the cam shaft in my Hemi. I ordered a new cam from Bullet that is NOT so aggressive. Mine should have never been in a street engine with so few cubes...