Recent content by 68chrgrguy

Thanks for all the info. Just bouncing more thoughts off everyone. I've tried to find info on known 6-AL failures. Couldn't find anything like what I'm experiencing. I've thought about updating it anyway. As far as trash in fuel tank, I'd think it would starve the engine and it wouldn't run...

Yep, ballast resistor removed when I put in the MSD distributor and 6-AL

I did replace the magnetic pickup in the distributor, no change. I'll have to try the fuel cap, kinda makes sense. I re-wired the car when I built it, been looking at everything, looks good so far

Sure have me thinking. Sounds familiar. I also moved my battery from the trunk to back under the hood. Seemed to help a little, but not fixed yet. I built the car 15 years ago, and starter and relay are getting old. I'll have to check them.

This is why I was thinking it could be the ignition switch. If it's failing, or corroded, it might drop volt to the entire system.

Never thought of that. Do you think it maybe loosing voltage at the relay and then to the MSD box?

Not using the stock pickup tube, I put in a welded rear sump.

I'm not using the stock pickup tube. Have a rear sump welded into the tank with a pre-filter to the pump.

I forgot to mention. I did a new coil too.

Hi All, Question for everyone. My Cordoba developed a problem that I can't seem to troubleshoot. After about 30 minutes of driving, the engine stalls. Sounds like it runs out of gas, in other words, it doesn't just shut off. Then, it stalls about every five minutes after. Each time, I wait...