Recent content by 69 Wedge

Damn , I should have polished out the ribs in mine.

You are correct Sir. I always thought polish exhaust ports slick but not intakes? but I am old and stuff changes.

Sorry I read it wrong. 350cfm is very good. No telling what you can do the TF270's. Impressive

Not you

You have never seen the Stealth's over 320? But the you state "you have ported them to 350?

No not you IQ52

You must sell Trickflow's

Muscle motors and Modern cylinder Head both flowed the Trick f. 240's got 290 and 296 on intakes. save your money, CNC'd Stealth's flowed on same bench 329. Past quality problem's have been solved. MCH has since ported hundreds of Stealths with no problems. I'd like to see the MCH port heads...

I already had new rockers, pushrods and Hooker comp headers. To run Trickflow's you need special headers for angle plugs, different length pushrods, longer rockers and longer head bolts. I did have to change v.springs and retainers for the roller cam on the Stealth's

I have a 400/512 stroker w/modern cyl. head cnc stealth heads. 10.4 compression, comp cams hyd. roller 576/608 lift 240-250 at 050 lift. Edelbrock performer rpm intake w/950 quick fuel carb dyno'ed 660hp at 5700rpm 707ft.# torque at 4400, bolted heads on out of box no problems. 3/8 push rods...