Recent content by 70NetRT

70 RT tail panel clips. Found on the internet, not my pics.

PM sent

I don't have some of those holes in the rad cradle. This is my brother's 70 Coronet. It has a 22 inch rad cradle and I believe it hasn't been touched. As for your third pic, there should only be one screw hole there for the windshield wash jug (the one towards the back) There should be a...

70 Coronet, The unlabeled holes are for the interior firewall insulation pad nails.

Not my car but this shows the boot cover installed.

Here are my two.

Original off my brothers 70 Coronet. Unfortunately the jug was badly cracked so I just salvaged the pump and cap.

Inbox full. I will take 2 thanks

I'll take it.

The lower bolts are 5/16-18 x 1.00 hex head SEMS (bolt to 5/16-18 U-nut on the angle bracket on cross brace) Not my photos (from a old ebay listing I believe)

a few reference photos I have collected. Some appear to be unmolested trunk lids.

On a 70 it is a factory hole. The clutch (neutral) safety switch wire goes through the firewall to the starter relay. You can see the grommet on the switch wire in the attached pic. For automatics it is not drilled and is just a dimple in the firewall.

Not on the firewall (probably wouldn't hurt to add one). For 1970 the engine ground was part of the negative battery cable and attached to the rad cradle.

The unmarked dimple holes are for the interior firewall pad plastic nails.

try Roseville. Ignition Switch/Dash Connector | Roseville Moparts