Recent content by Beekeeper

the remaining pictures

Here’s some pictures with measurements for the lifting attachment. The two pieces of 2 1/2” square tubing once drilled will need a 1/2” nut welded to them for securing the 1/2” bolt that holds the cross bar in place. The rest of the tubing is 2” square thin wall also the 2 mounting holes for...

I will post up some pics and measurements this weekend when i’m back in the shop

Man I appreciate all the birthday wishes from you guys!

Your actuator is worn out you will need to replace it.

Yep that is the inner tubing that’s part of the torsion bar hex socket

Indian head gasket sealer works just fine as well https://shop.advanceautoparts.com/p/permatex-original-gasket-shellac-compound-2-oz-20539/7160106-P

I would be glad to give you measurements for it. I designed it to work for A,B and E bodies as well although I’ve never been an E body guy.

ohm the sending unit again this time take it through the full range slowly and verify that it doesn’t open circuit anywhere through the full range. what you show here points to the sending unit being faulty. Reading the ohms at full and empty only doesn’t fully test the the function of the...

It will work with the correct arm. I marked up your photo indicating what notch the cover tab goes in. The three speed motor is interchangeable between the different years and bodies.

Push washer

https://www.forbbodiesonly.com/moparforum/threads/for-sale-section-rules.67486/ The ad requires a price or the mods will delete the thread.

looks like 18 spline to me

What is the info on the flat pad on the block in front of the intake valley?