Recent content by Ben Mowery

So I have the repop bezels I am using on my GTX. I have some older nuts removed from the original bezels. I also purchased new nuts that are for a 70-71 Challenger. Does anyone know if these will work or should I just clean up the old ones and reuse? Also, is there a trick to keep the bezels...

Thanks. These need cleaned up a little.

I have a set of the top door edge moldings off my 71 GTX I am not going to use. These are the thick wide ones that set on top of the door and the quarter. the quarter ones are shaped like a C. These are usually pared with the roof edge moldings. I have a full set plus a few extra pieces. I...

Looking for definitive information on how the rocker moldings attach. I have heard some say just screws in the holes and some say clips. I have a set I am going to put on my 71. Holes are there in the body but no idea other than screws how they would attach. If they were flimsy chrome pieces...

Thanks to all. I managed to find one thanks.

looks like at sometime I must have misplaced the e-brake lamp switch for my car. Looking to see if anyone has a good switch they would part with before I end up buying a whole assembly to just get a switch. Let me know Thanks!!!!!

I was looking to see if someone can tell me or show me where the metal wire supports go in the inter behind the dash for the 71 model Plymouth B body. I am referring to the sheet metal brackets the part of it looks like it dipped in plastic or rubber and it holds or supports wires. Thanks! Ben

I am working on installing new brackets for a manual trans console. I was wondering if anyone had templates or pictures with dimensions for the bracket locations. Any help would be appreciated. I almost forgot to mention that I am working on a 71 GTX.

Looking for a passenger door skin for my 71 GTX. Closer to Indianapolis the better.

I am currently converting a Satellite hood to an air grabber hood for my 71 GTX. I found the template for whole locations, but I am looking for an image of how much the front brace gets trimmed as well as other inside modifications for the hood to allow it to look somewhat correct. I know I...

Where are you located? Is shipping an option?

Sorry, I was in an auto accident on top of getting ready to go out of town for spring break. I do have some interest in it. I will try to catch up with you when I return.

inbox emptied. Please try again.

Looking to see what’s out there. No preference in complete or partial assembly or ratio. Ty. Ben

Looking for a 71 or 2 Plymouth B body trunk lid. Looking specifically for one in good shape that has the cut-outs for the trunk spoiler. Let me know what you have and what you are asking for it.