• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Bird 426's latest activity

  • Bird 426
    Bird 426 replied to the thread Edelbrock A12 intake ID help needed.
    Okay guys, Thank you.
  • Bird 426
    Bird 426 replied to the thread Edelbrock A12 intake ID help needed.
    Curious, what designates A 12? I was under the impression that '69 's were A 12. I know that 6-pack was offered in '70, but I did not...
  • Bird 426
    Bird 426 replied to the thread Hydraulic camshafts in general.
    An engine builder that I know says that solid rollers start to get out of round at around 5,000 miles. I just took a solid roller out...
    • 20231120_193141.jpg
  • Bird 426
    Bird 426 replied to the thread Hydraulic Roller Cam Button End Play.
    I had the back cam plug out " water freeze plug", and used a dial indicator. I also used the roller bearing cam button, not the nylon...
    • 20231120_193141.jpg
  • Bird 426
    Bird 426 replied to the thread 440 no start, any guesses guidance?.
    Electronic ignition doesn't like low voltage either. If you have everything up to the distributor, rotor and cap okay? When starting...
  • Bird 426
    Bird 426 replied to the thread 69 Coronet R/T fire.
    I'm almost 76, wiring is easy, plug and play. Pull the front seats and steering column if you replace the dash harness. Just finished...
  • Bird 426
    Bird 426 replied to the thread Steering pump leak cause.
    The reservoir can must be close to perfect for the o-ring to seal.
  • Bird 426
    Bird 426 replied to the thread Minii starter disaster job..
    The starters alignment is the snout into the bellhousing. That top hole, too large, larger than the bottom bolt hole, is just there...
  • Bird 426
    Bird 426 reacted to koosh's post in the thread Anyone mount External fuel pump? with
    Like
    Like
    .
    Very interesting…..i need to come up with something like that…. This is my pump on a different car
  • Bird 426
    Bird 426 replied to the thread Fan belts squealing - can’t seem to solve.
    Two things, is that a cogged belt? Second, if a belt bottoms out in a pulley groove, it will never stop squealing. A/C belts were...
  • Bird 426
    Bird 426 replied to the thread six pack tuning help in NJ.
    I would go with the tall yellow springs in the outboards. To adjust them properly, should have Promax base throttle plates in the...
  • Bird 426
    Bird 426 replied to the thread six pack tuning help in NJ.
    Can you tell us what you have? Stock carbs or Promax modified? Are you able to take them apart yourself? I just went through this...
  • Bird 426
    Bird 426 replied to the thread Thosaf extractor set junk.
    I am not much of a fan of extractors.
  • Bird 426
    Bird 426 replied to the thread Pro-pinions requested!.
    What would actually look better all around would be the housing that has 2 sender locations.
    • 20250606_201439.jpg
  • Bird 426
    Bird 426 replied to the thread FITECH 6 PACK.
    Having built an Experimental aircraft, unless there is a call out, there isn't anything special about aircraft aluminum. For tubing...
Show older items
Back
Top