Recent content by bullwy

wanted two consoles: one for 68 coronet and one for 69 charger, both 4 speeds. If possible complete. Thanks, oliver

Yes. Once i got it from the mechanic i measure the length. I assume they are too short.

Final update: bent pushrod and pushed out lifter caused the zero oil pressure. Interestingly this has happened now twice in just 130 mls.

update: no damage to the crank and bearings (gladly). next check is the oil galley plug at the front of the engine.

He said he has a tool to attach to the oil filter port. I will go to the shop today and check at least one bearing. In my experience zero oil pressure and worn out bearings always means horrible engine noise (missing here) and overheating (also missing). I also will check if the oil pressure...

the pressure was measured directly at the oil filter port, not at the rear oil pressure pick up port on the block. I'm sorry when I was ambigous, I meant worn out bearings (not literally "broken" bearings).

thanks. the pick up is not blocked, because the pump is delivering 50 pounds when idling. it just seems that the oil is not being fed back to the oil pressure pick up port. but is it really possible that due to broken main bearings and no obvious engine noise characteristic for crankshaft...

When I drove on the freeway I noticed that the oil pressure on my 440 was suddenly dropping from 70 psi to 60, then 50 and then 25 and then to zero, this within probably 30 seconds. I was able to shut down the engine immediately. I let it sit for 10 minutes and was checking any leaks under the...

Thanks

Forgot: title not required.

Looking for a fender tag.

...looking for. New or excellent condition only.

still looking

Both

Looking for this. Any offers? Only good to excellent condition, please.