Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Went to install new bearings and seals and realized that someone in the past wasn't too good with a cutoff wheel and put a big slice where the inner seal rides. I would prefer a driver's side shaft so I don't have to change the studs over.
This is for a 8 3/4 axle.
Thanks!
Tyler
Hello,
I need 16 stock big block valve spring retainers (not Hemi). I know somebody has some stockers laying around that they don't need anymore.
Thanks!
Tyler
Hello,
I need 16 stock big block valve spring retainers (not Hemi). I know somebody has some stockers laying around that they don't need anymore.
Thanks!
Tyler
This center section was just removed to swap in the original ratio in a 69 R/T. It is basically ready to swap in and is in good shape mechanically. Backlash is .008". No whining. Could use a pinion seal. Easily passes test outlined in the service manual for testing the Sure Grip unit.
Pics...
I am selling the following:
- (3) 69 Road Wheel Trim rings. Part number decal is no longer there, but they should be PN 2944161. They have the 4 clips around the circumference of the ring and the correct valve stem opening. All three vary in condition. One of them I would call an 8/10. I...
Are these what you are looking for?
http://www.megapartsusa.com/proddetail.asp?prod=110-C8223 for drum brakes
http://www.megapartsusa.com/proddetail.asp?prod=110-C8224 for disc brakes
Hello,
Putting a stock carb back on, so I no longer need this one. It is off of a running engine so nothing needed.
It has less than 5000 miles on it.
Asking $275 shipped to anywhere in the country.
Thanks!
Hi guys,
I am almost done getting parts for my 69 Coronet. This is a list of stuff I would still like to get:
Two ball joint nuts (original three point castle nuts)
Used ballast resistor with PN 2095501. I am going to bypass the resistor.
4 bolts for the air shield, rock guard...