Recent content by cwmoss

Just went and looked at mine, it's Off, Heat, Defrost and Cool.

Thanks guys. A friend has one of these tools I think. I am gonna be seeing an "old timer" who did glass work back in this era.

Got back into a 65 After selling my 65 4 speed car to a fellow in Germany, to buy a C2 corvette, I realized how much I liked that Belvedere, and didn't like the C2 because it didn't have much space to carry chairs and coolers. So I got rid of the corvette and got back into bigger cars like...

- - - Updated - - - I am probably gonna just take the rear glass out and put a new gasket back in. I don't see any clips. I do have a service manual, but haven't made out what they were trying to point out.

Need a few trim pieces if you still have any. Back glass lower pass side trim. The trim that looks like a hockey stick coming down from the roof over the rear side glass, both sides. Thanks, Daryl (cwmoss)

I am back into a Mopar, a 65 Belvedere II hardtop. I need to know how to remove the trim from the back glass. Looks like someone replaced the gasket, but when they installed the trim, they got the pass side trim too far to the center of the car and the part that goes under the side piece won't...

This a buy! Someone jump on this so it won't be tempting me!! cwmoss

Yes it is. How could you tell? Daryl

The 65 is sold pending the balance of funds. A deposit has been made. Thanks Tobias and Gunter. Daryl (cwmoss)

Thanks guy's for the compliments. I hate selling, but have to. Daryl

I have to let go of my 65 Belvedere. It is a factory big block 4 speed car with bench seats. It was a 361 car, but now has a '69 383 roadrunner engine that has been balanced. It has a 750 Holley and a Mallory vac. adv. dist. I put a TTI exhaust system on it a few months ago and a new set of...

I recently met a fellow who lives just outside of Houston, who had a hemi built for his 65 Satellite. One or two lobes went flat. He sent the cam back to the builder and when asked what oil he was using, he said Mobil 1. The builder reccomended Z-Alt and he hasn't had any problems since. FWIW...

Glad I came across this post. Just last night this was happening. This was something I was going to research today. I don't drive my 65 very much at night, but when I have, going down the road everything is fine, but when you get caught at a light, the light's all get dim and the ammeter shows...

When I bought my exhaust kit from TTI, the instructions said to measure from the center of the harmonic balancer to the frame rail on each side. There should be a 3" difference in the measurement, with the smaller measurement on the pass. side. The engines are in the car at an angle, for what...

Call them and ask. That's what I did. cwmoss