Recent content by DieselPower

Try a different gauge.

Hello. I need the OEM bolt for the master cylinder cover hold down bolt for a drum brake master cylinder. It’s 1/4” x 1” hex bolt with an “H” marking on the head. Also still looking for these: WTB - Air Shield/Rock Shield/Gravel Guard Bolts Thank you!

I should have clarified. I'm looking for the ones with the H on them. Thank you.

Looking for some of these bolts. There are 6 total. I have 3. Thanks

I have the strap, but not the bracket or hardware. This is the style that uses sheet metal screws, not the studs and bolts. Anyone have this? Thank you

Just looking for the small black button for changing the track on a 68-70 8 track radio. Anybody have one or is anyone reproducing them? Thanks.

Tried to PM you, but your inbox is full. Let me know how much you would want shipped to 61733? Thanks!

Went to install new bearings and seals and realized that someone in the past wasn't too good with a cutoff wheel and put a big slice where the inner seal rides. I would prefer a driver's side shaft so I don't have to change the studs over. This is for a 8 3/4 axle. Thanks! Tyler

PMed you. Thanks!

Hello, I need 16 stock big block valve spring retainers (not Hemi). I know somebody has some stockers laying around that they don't need anymore. Thanks! Tyler

Hello, I need 16 stock big block valve spring retainers (not Hemi). I know somebody has some stockers laying around that they don't need anymore. Thanks! Tyler

Here are pictures.

This center section was just removed to swap in the original ratio in a 69 R/T. It is basically ready to swap in and is in good shape mechanically. Backlash is .008". No whining. Could use a pinion seal. Easily passes test outlined in the service manual for testing the Sure Grip unit. Pics...

69 style trim rings are sold. 70 and newer style still available.

Any interest or offers?