Recent content by duster22

Yes they would look good. Frank

I would say a 15 x 7 off of say a late 70's 5 th Ave. But could be off a Dodge pickup. We always called them the " flat dish " wheels , cause of the way they curve down then back up near the rim edge. The wheels work just fine. Frank

A bigger pic of the front of the wheel would give me a better idea of what the wheel actually is... Frank

I talked with a gentleman at the Mopar Nats a number of years ago and I had a set of the road wheels at that time. Three of them were original wheel and one was a repop. This guy worked for one of the wheel manufacturers back in the late 60's and early 70's. He told me they made a number of sets...

I have two brand new 15 x 6 Magnum 500 wheels. I also have two 15 x 7 Magnum 500 wheels, but the 15 x 7 wheels have a 5 1/8" backspace, these were made for a B body 8 3/4 rear end under an A body car, that's why the extra amount of backspace. I also have centers and lugnuts. Let me know if...

I may have two 14 x 5 steel wheels , I am pretty sure they fit the 10 inch dogdish , don't know about the disc brakes. Are you sure you want 14 inch or 15 inch ?? Frank

Hello , I have two NOS domes 03580466 with retainers and bolts and one repop dome with retainer and bolts. The NOS domes measure 2 1/8 inches and the repop measures 2 3/16 inches. I also have the boxes for the NOS domes , but they are worn but readable... If you are interested let me know...

Are you wanting to use the correct 10 inch dog dish caps ?? If so then those wheels are hard to find , but those wheel can be made , by using the repop wheel centers that I have for the 10 inch dog dish caps... Frank The Wheel Guy

I have two 15 x 6.5 big bolt ralley wheels, but I am in Indiana , so shipping might be pricey , cause you are in CA , correct. Let me know in PM. Frank

Are those the trim rings with just 4 s clips to hold them on ?? I have 4 used ones , will have to get them out to see their condition. Frank

I would love to see a Magnum 500 center cap that has a hole from back to front, never seen one. I have had new, used and repop Magnum 500 centers, never had a one that had a hole. Could someone post a picture of it ??? Frank The Wheel Guy

I just went and looked up prices at Coker , Jegs and Summit , steel wheels. Wow , $170 to $180 each for a start and that's the narrow sizes. I had not checked prices lately. Frank

Just for info , Coker shutdown Specialty Wheel the summer of 2020 , they no longer exist anywhere on the net or otherwise. They killed all the smaller vendors that dealt with Specialty and their deals. At least that's what they did to me. Frank The Wheel Guy

Unless you get some custom steel wheels made with my wheel centers that accept the correct 10 inch dog dish caps. Frank

Look for the " L " on the end of the wheel stud. Frank