dvw's latest activity
-
dvw replied to the thread Had a good day racing my dads Roadrunner.Doesnt get any better than this, congrats Doug -
dvw replied to the thread Vapor-Locking... the bane of my existence..Not uncommon for clear filters to see air. If there is fuel in the filter I would question if thats the issue. When it quits does it...
-
dvw replied to the thread Home Alignment Results.You alway move both wheels in the direction the wheel is off. In your case the wheel is off to the right. So think of it like this. The...
-
dvw replied to the thread 1964 Push Button 727.Do you have a push button valve body? Or is is a floor shift 64/column shift 65 valve body? The rooster comb, manual valve, and nuetral...
-
-
dvw replied to the thread 1964 Push Button 727.Im assuming the 1/2 buttons wont press in?Which neutral safety switch? If it's the nylon style plunger, the plunger sets to deep and can...
-
dvw replied to the thread Home Alignment Results.I'm not sure where you got this info. It will pull towards the side with the lower caster. Higher camber can cause it to pull as well...
-
Your left to right readings are very close to equal. I doubt that caster or camber is causing it. Tires can cause a pull. I assume they...
-
dvw replied to the thread Drums for Racing.In the past I've run mid 10's@128 using 10" drum brakes. It wasn't bad at a normal length track.Th biggest concern is pulling right or...
-
dvw replied to the thread What is the general opinion of doing a 440 block .060 over?.It's a street motor with cast pistons. Nobody would blink an eye at .030" over with the cylinder walls .015" thinner than stock. At...
-
dvw replied to the thread Broke the truck on the way home from Bowling Green..After letting the loctite cure for 48 hours took the truck out today. Drove and shifted perfect. Ready to tow to Milan next Sunday. Doug
-
dvw replied to the thread I'm Stalling on my 727 stall converter choice.I agree with the stock Hi Stall 10 3/4" used in 340's. It'll be darn close to what you want. And there cheap. Doug
-
I would use a stock 340/383 10 3/4 convertor, not the 11 3/4 version! They are inexpensive and should get that stall or close in your...
-
dvw replied to the thread Plastic or insulation preference.One box is 36 sqaure feet I covered the floor and any access hole in the doors. I've seen people put it on th eroof as well. The more...
-
dvw replied to the thread Plastic or insulation preference.Kill-Mat is the same as Dyna-Mat for less money. If you aren't worried about weight this stuff is great. Really quiets the interior from...
