Recent content by earlymopar

I'm looking for someone with a (non repairable) small block 904/727 or that has parts for same (or a broken bell housing). I need the section where the starter mounts to cut-out and use on my engine while its on the stand (I dont' have space to add a full bell housing or automatic). Let me know...

Surprisingly 1st to 2nd gear really doesn't come on too fast and you're right tire diameter is a big factor. I was amazed when I ran the numbers on each gear with the 4.56 ratio and still have a (calculated) 140 MPH top end in 5th.

It's sure interesting to see where some of us are with gear ratios and how spread out we are across a large range. Of course there are several factors. I'm running a TKO600 and 30.75" tire diameter and 4.56 ratio. I started with 4.1 ratio that Liberty's suggested and didn't like the outcome...

It would seem that at a 7k lb. capacity that the Ram will be close to the limit and the Suburban likely over capacity?

Any luck on locating these parts fellas?

If yours is an A series (Poly) and not an LA I may be interested. Let me give some thought on the need for any other parts.

I am certainly interested Dodge33. I'll wait for you to confirm the dip stick and tube. Pictures would be great.

Understood. Thank you.

Looking for: - Poly 318 single groove water pump pulley (can also be LA series pulley up to 68') - Poly 318 dip stick and dip stick tube - Carter 6902 Fuel Pump - (Added on 12-31-22) early to mid-60's Poly 318 Timing Tab (or 273 Please PM me here. I do not text.

What year is your 318 pulley from?

Beautiful car, perfect color.

Thanks Matt. I hope all is well with you. Steve did get in touch with me and sent me several pictures of the car in-process and completed at the show. The good news is that he finished it exactly as Curt had planned. The only thing I see he "changed" was that he removed the factory 6...

Sorry about that. Box has been corrected. Contact member "chooch" on this site. I had forgotten he is a member here.

I can't tell if you found a set or not from your last post. I sold a set last year to a fellow in PA whom I believe has more than one set. Please send me a P.M. and I'll provide his contact info. if you're still looking.

- New Dedenbear Linkage Throttle Stop Kit # TS10K = $250 ($464 @ Summit without the large cylinder mount and extra (red) tubing) (The kit includes both the larger tank and air cylinder shown below.) - New ZEX / Comp Cams #82010 Nitrous Purge Kit = $75 ($130 @ Summit) - Thermo Tec Copper Header...