Recent content by fd2blk

PM Sent

When you replaced the fuel pump are you sure you got the tab on the FP under with the fuel pump shaft from the cam?

I picked up a 71 Road Runner in January that needs a complete restoration but was supposed to have a rebuilt motor and trans. Well since the previous owner decided to bolt the trans up w/o the flex plate or converter I had to pull the trans and install the parts he left out and after a few...

Just did my fuel lines this week on my 71 RR. Not sure if it is the same but here is what I found On my Car all 3 lines run down the Passengers side At the engine bay The Fuel Line connects to the Fuel Pulp (Duh) The output of the the Fuel Pump connects to Fuel Line Gas separator The separator...

PM sent

I have a 71 440 Roadrunner and can't seem to find and exhaust system other than 1 system from Accurate that will mate to the stock exhaust manifolds. All the systems I find such as the Flowmaster system are either Header or downpipe back. Anyone know of either a place to source the down pipes or...

Joel I will send a check tomorrow

PM sent

Jim I owe you a beer you just saved me $150 thanks for the hook up

I have used the duplicolor and rustolem vinal paint with great success. The key for me has been a good wash with soap and water and use of wax and grease remover. I also lightly use a green kitchen scrub pad as part of the prep. I did all the final in my boat nearly 3 years ago and it still...

Thanks for the reply and yes it is the long shaft with the dual shifter mount. Is there any way from the partial VIN to tell what type of car?

I am pretty sure year one caries them since I have a new tank, straps and the j hooks in the box from year one that came with my car

Would love to do that but I don't have a drive shaft at all.

Just looked it up again and you are exactly correct looks like PN 2996 101 for the 340, 383, 440 and the 426 with the 8 3/4 rear end using the 7290's so 51.5 is about an inch to long. Ugg is this not a common drive shaft?

I am interested just not sure what size drive shaft I realy need the interchange manual is really confusing. Let me do a little more research and get back with you do you knwo what car it came out of engine trans rearend? Thanks