Recent content by Harry Williams

I need the pad adapter if you decide to split it up? Thanks

Found them thanks to all

I need 6 finish panel clips for my 70 charger. All help appreciated Thanks

I need 6 clips for 1970 charger rear finish panel clips. All help appreciated Thanks

I need 6 factory clips that hold the rear finish panel on a 70 charger. All help appreciated Thanks

Does 68 and 70 charger have the same rear seat frames? Thanks

If it were 10.5 i would do it but it 11 inch. Thanks

I need a 10.5 inch 18 spline clutch set up for 70 up 10.5 bellhousing. Centerforce says df810739 should work. All help appreciated Thanks

I am looking for a set of black rear seat covers for a 1970 Dodge Charger part number MB 741 100 From legendary interiors. If anybody could help me out with this it would be greatly appreciated . Thank you

I was just wondering if they make a regular small block 11" bellhousing I don't want one of the Lakewood type blow proof ones. Dont want to cut the floor. Al help appreciated Thanks

Can you put a regular shifter in a new 6 speed manual transmission ? I want to use a 6 speed manual transmission out of a new scat pet car in a 74 challenger. I want to put a shift your handle in it and was wondering if you could do that Other than the factory setup. Also would that...

Also need e body 4 speed. Thanks

I need a drivers amd quarter for 70 to 74 challenger perfer 74. I know they are different but they will work. Also need a rust free deck lid for 74 challenger. Closer to chicago area the better . All help appreciated Thanks

What back spacing did you use? Is 5 1/4 on a 17 inch wheel too .uch for the front?and 4 3/4on the rear ok? Thanks

I wouldn't have thought you could get a 727 hooked up to a 6.4 will see if i can find a adapter.