Recent content by hill

Looking for a pos 3.23 or 3.55 for a 489 casting or just the gears. I have a pos in it now with 4.30 gears.

I have a 1970 gtx and i want to put 15x7 on the front and 15x8 on the back. What back spacing do i need to get for the rear

I have a 1970 GTX with an auto trans. The people i get it from were going to make it a 4 speed car, so they changed the rear end to a 4 speed rear(witch is way to low for what i am going to do with the car). My question is what were the stock gears for the auto. I have a beefed 440 with a 727...

need for a 1970 gtx need the kick down rods for the trans and the hood latches the ones on the hood

witch one had the cover on the back and witch one did not mine dose not have the cover

still looking for a drive shaft. Will a shaft out of a cornet fit same year??

I have one that is rebuilt no bell or linkage

wanted 1970 gtx driveshaft 440 /727

Oh yea thanks all of the help

I pulled the cam and ran the numbers on it. It is a comp cam. When you say thick how thick. I called the those guys on the stall and He looked it up and said I need external balance so that what they sent

OK I just found out i need a 2800 stall How do I tell if the motor in external balanced or internal balanced. The motor was rebuild when i got it and no specs were given so i pulled the cam , heads and the oil pan. The crank looks cast but has been balanced along with the new rods with 0.30 dome...

looking for a dr side fender in good shape

Thats good to know! Now i need to get the smaller one and the 11in converter Oyea are the splines the same for the 2 converters

Is there only 1 flex plate for the 440 727TF or does it depend on the torque converter size. The best i can remember there is only 1 for that combo

so what your saying is i need the 11in