Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
It has an electric choke on it now. Does fully open when it warms up and closes when you hit the throttle for startup. We have a 8 1/4 rear end with 3.21 gears. The transmission was rebuilt and had a shift kit and new convertor installed I was told they rated it for 400hp. Is there an easy way...
Another thing I just thought of is it is a pain to cold start. But I did go to the gas station turned it off filled up and it did start right away. What I've been doing after it sits for a day is hit the pedal twice and try to start it usually without any start. Should I just be constantly...
I will most definitely give that a try. Sorry about the terrible explanation of all of this. For the no guts. I manually put the 727 into first gear and slam on the gas it acts the same if you were to gradually give it 1/4 throttle or full throttle. Takes a long time for rpm to rise. When in...
I have the fuel line routing in the front of the block and running 91 octane gas. It has a Edelbrock performer cam, Edelbrock ld340 intake, headers. Temps around here get to 80 max.
Hello Everyone,
I have a very simple setup. I am running a 74 dodge charger with a rebuilt 318, edelbrock 600 carb, mechanical fuel pump. The car is extremely hard to start during a warm or cold start, and while driving it has no guts. At a local car show I was told that it probably has to do...
Hello Everyone!
I currently have a 318 with a edelbrock LD340 intake on it. It has a port for a 1/8 npt gauge which I tried to make a t for. One side analog gauge (factory) and the mechanical gauge. That doesn't seem to be working. I see people have suggested using a water neck spacer but am...
Hello Everyone,
I have a 74 charger with a ld340 edelbrock intake on it. I have the kickdown linkage on the car but noticed that I'm missing some parts. I know I need at least these two springs circled but not sure where I can find those and I am unsure what front bracket to get as I have found...
Hello Everyone!
I have been working on restoring this 1974 dodge charger for over 4 years! I have learned so much from the forums, groups, and other YouTube channels. I have decided on recording and uploading video to YouTube not only to document what I have accomplished but to give other...
https://img1.wsimg.com/blobby/go/3d63a65e-2290-46eb-bee7-bb8d68a8ae13/downloads/5.75%20LED%20Headlight%20W%20Turnsignals%20Installation%20.pdf?ver=1597162189819
Best I could find.
Didn't come with any instructions. I asked the seller yesterday for some diagrams so I can make sure I set them up right. They have a 3 prong on the back, single lead for the DRL, and another single lead for the Turn Signal.
Alright guys so here's my question today. I am a newbie when it comes to anything electrical so sorry in advance as I am still learning. I have purchased LED style lights with low, high, DRL, and turn signal in one unit. Below I have copied a link for the wiring diagram.
My plan was to have the...