INTMD8's latest activity
-
INTMD8 replied to the thread Sheet Metal Divider, How to?.Bead roller is 100% the way to go in my opinion. If you send me the stuff I would do it for you but probably not the most convenient... -
INTMD8 replied to the thread Sheet Metal Divider, How to?.Just take your time and make the templates perfect. If you cut it shy don't guess, even add some folded tape to the edge and trim again...
-
I'm thinking rivnuts (5 or 6) across the top (forward facing) edge to tie the divider and package tray together (will break the edge of...
-
INTMD8 replied to the thread Sheet Metal Divider, How to?.I like doing work like this. I would use poster board for templates. Aluminum sheet, bead rolled for aesthetics and added stiffness...
-
And dont forget old harmonic dampners can slip and mess up your timing mark! Maybe it wasn't all that advanced.
-
INTMD8 replied to the thread Can someone explain this….It's from Holley but I believe it's the same tank.
-
INTMD8 replied to the thread Can someone explain this….On my 69 Charger with efi tank (but stock dimensions) the middle of the tank is the lowest point to the ground and that's where the...
-
INTMD8 replied to the thread 440 breaking up mid rpm.As mentioned, may be fuel delivery. Empties the front bowl and when you go wot it starts draining the rear.
-
INTMD8 replied to the thread AEM Air/Fuel gauge seems to be non responsive.It should be showing 14.7 if calibrated for gasoline, it doesn't know if there's any ethanol in the tank. So 1.0 lambda will display...
-
There is no such thing as the cam being “180 out”. However, you can certainly put the distributor in 180 out. Pull out #1 plug, put...
-
Few more odds and ends today. Forever sharp steering wheels. And needed to changes the lights to be able to see much better at night...